Software Bisque Knowledge Base Article – 262

LAUNCHING CCDSOFT CAUSES PAGE FAULT IN MFC42.DLL

ISSUE

After successfully installing and running, the following error message is now displayed when trying to launch CCDSoft:
“This program has performed an illegal operation and will be shut down. If the problem persists, please contact the program vendor.”
A second message shows:
“CCDSoft caused an invalid page fault in module MFC42.DLL@…”

RESOLUTION

A related registry entry has probably been corrupted, preventing CCDSoft from running successfully.

Follow these directions to correct the problem:

1. If running, close CCDSoft.
2. Open the Registry Editor (Start / Run, type REGEDIT, then select OK).
3. Switch to the HKEY_CURRENT_USER window (listed under Window menu).
4. Open the key list to Software/Software Bisque.
5. Delete the key named “CCDSoft.”
6. Exit the Registry Editor (your changes will automatically be saved).

You should now be able to run CCDSoft successfully.

APPLIES TO

General

KEYWORDS

SBKB

This article was formerly published under the identifier Q508KB in Software Bisque’s prior knowledge base.

Last Reviewed: 11/24/2004