Software Bisque Knowledge Base Article – 197

SCREEN NOT UPDATED WHEN CONNECTED TO TELESCOPE

ISSUE

The recompute interval is ignored once connected to a telescope, that is, the screen no longer updates in horizon based modes.

RESOLUTION

The “Cross hair update period” in the telescope setup is set to low and requiring so much processor time that the system never goes idle to allow auto recomputing. Raise the “Cross hair update period” to allow the screen to update. This phenomena is entirely CPU dependent.

APPLIES TO

Telescope Interface

KEYWORDS

SBKB

This article was formerly published under the identifier Q398KB in Software Bisque’s prior knowledge base.

Last Reviewed: 11/24/2004