› Forums › Knowledge Base › Knowledge Base Articles › 188 – CANNOT ESTABLISH COMMUNICTIONS TO ST-6 W/CCDSOFT

Viewing 1 post (of 1 total)
  • Author
  • August 23, 2005 at 2:00 pm #88116

    admin
    Participant

      Software Bisque Knowledge Base Article – 188

      CANNOT ESTABLISH COMMUNICTIONS TO ST-6 W/CCDSOFT

      ISSUE

      When the ST-6 is connected to COM1, and a link with an ST-6 is attempted, the message “Camera not responding, please check…” appears.

      RESOLUTION

      If communications with the ST-6 cannot be established, trying connecting at 9600 baud. Occasionally, attempting to establish communications at higher rates results in failure.

      APPLIES TO

      General

      KEYWORDS

      SBKB

      This article was formerly published under the identifier Q387KB in Software Bisque’s prior knowledge base.

      Last Reviewed: 11/24/2004

    • Author
      Posts
    Viewing 1 post (of 1 total)
    • The forum ‘Knowledge Base Articles’ is closed to new topics and replies.