› Forums › Knowledge Base › Knowledge Base Articles › 186 – LOSE ST-7 IMAGER LINK WHEN ESTABLISH GUIDER LINK

Viewing 1 post (of 1 total)
  • Author
  • August 23, 2005 at 2:00 pm #88114

    admin
    Participant

      Software Bisque Knowledge Base Article – 186

      LOSE ST-7 IMAGER LINK WHEN ESTABLISH GUIDER LINK

      ISSUE

      When using CCDSoft to establish a link to the ST-7 (and ST-8?) guider chip, the existing link to the on-board imaging chip is broken. It takes several attempts to re-establish this link.

      RESOLUTION

      CCDSoft v4.00.005 addressed this problem.
      Obtain an update (from our web site, via e-mail, or through snail-mail).

      APPLIES TO

      General

      KEYWORDS

      SBKB

      This article was formerly published under the identifier Q385KB in Software Bisque’s prior knowledge base.

      Last Reviewed: 11/24/2004

    • Author
      Posts
    Viewing 1 post (of 1 total)
    • The forum ‘Knowledge Base Articles’ is closed to new topics and replies.